ABB
HA-M-0.6.1
free@home Heating Actuator, 6-fold, 230 V, MDRC
Product code:
2CDG510008R0011
For controlling thermoelectric actuating drives in heating/cooling systems. The outputs are protected against short-circuit and overload. The bus can be connected via enclosed terminal block.
Description
This devices has six channels and serves as an actuator for the activation of heating systems via conventional thermal actuating drives.
- Six channels for the activation of actuating drives.
- Per channel, each device supports voltages of 24 V AC up to 230 V AC (this makes the use of all conventional thermal actuating drives possible).
- Three channels can be protected together by a circuit-breaker.
Technical Details
Specification
Power supply: 24 V DC (via the bus)
Bus subscribers: 1 (12 mA)
Connection (free@home): Bus connection terminal: 0.4 - 0.8 mm
Line type: J-Y(St)Y, 2 x 2 x 0.8 mm
Outputs
- 6 or 12 semiconductor outputs: 3 non-floating outputs each in the group. Protected against short- circuit and overload
- Rated voltage UN: 24 to 230 V AC 50/60 Hz
- Nominal current IN per output: 160 mA resistive load at TU to 45C
- Inrush current per output: Maximum 750 mA for 10 s at TU to 60C
- Caution: For the parallel connection of actuating drives (e.g. TSA/K) the technical data of the respective actuating drive is to be observed! The inrush current (750 mA) and nominal current (160 mA) of the output must not be exceeded.
Connecting terminals:
- Combi-head screw-type terminal (PZ 1)
- Connection cross section:
- 0.2 - 4.0 mm2 fine-wire
- 2 x 0.2...2.5 mm2
- 0.2 - 6.0 mm2 single-wire
- 2 x 0.2...4.0 mm2
- Tightening torque: 0.6 Nm
Ambient temperature
- Operation: -5C to +45C
- Storage: -25C to +55C
- Transport: -25C to +70C
Environmental conditions: Maximum humidity: 93%, no dew permissible
Protection type: IP20 Acc. to DIN EN 60 529
Protection class: II Acc. to DIN EN 61 140
Insulation category
- Over voltage category: III acc. to DIN EN 60 664-1
- Degree of contamination: 2 acc. to DIN EN 60 664-1
Mounting: On 35 mm mounting rail. Acc. to DIN EN 60 715
Built-in position: Any
Design
- Rail mounting device (MDRC): Modular installation device, Pro M
- Installation width: 4 or 8 modules a_ 18 mm
- Installation depth: 64.5 mm
- Housing, colour: Plastic, basalt grey (RAL 7012)
Dimensions: 72 x 90 x 64.5 mm (W x H x D)
Weight: 0.14 kg
CE marking: According to EMC and low-voltage guidelines
Properties
Properties
| Technology | Other Control |
| IP rating | IP20 |
| Mounting Width | 4MW |
